Guide to read pin code and program remote key on a Peugeot 307 year 2011 by using Lonsdor K518 auto key programmer.
Key information:
Original key: 2-button folding remote key
Frequency: 433MHz
Chip type: Electronic 46 chip
Device to program: Lonsdor K518 key programmer
Procedure:
Step 1: Read Pin Code
Connect K518 host with vehicle via OBD socket
Turn ignition to ON position
Select car band Peugeot-> Read Pin Code-> Type 1
During the procedure, car wipers brush and headlights turn on. It is normal.
Read pin code success.
Step 2: Program key
Select Peugeot 307-> 2006 up->Program key
\
Lonsdor K518ISE will require to enter 4-digit pin code to access
Enter pin code and confirm
Complete following steps within 15 sec:
Turn ignition off, turn ignition on and press YES to continue
Program success. Press YES to program next key or NO to go back
Programming completed
Step 3: Program remote
Follow steps below to program remote control:
- Turn ignition off and remove key
- Insert a key and turn ignition on
- Press on any button of the remote key for 5 seconds and then release within 20 seconds
- Turn ignition off and remove key
- If have more remote to program, repeat Step 2 to Step 4.
Done! Test the new remote key.
